Loading ...
Loading ...
Loading ...
6
IMPORTANT:
Before connecting power burner to gas source, make sure BBQ Power burner
control knobs are in the “OFF” position.
• Verify the type of gas supply to be used, either natural or LP, and make sure the marking on the
appliance rating label agrees with that of the supply.
• All pipe sealants must be an approved type and resistant to the actions of LP gas. Never use
pipe sealant on flare fittings.
• The installation of this appliance must conform with local codes or, in the absence of local
codes, with either National Fuel Gas Code, ANSI Z223.1/ NFPA 54, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2, or the
Standard for Recreational Vehicles, ANSI A 119.2/ NFPA 1192M, and CSA Z240 RV Series,
Recreational Vehicle Code, as applicable.
WARNING:
Gas valves are preset at the factory to operate on LP or natural gas. If you wish to
convert, be sure to contact your power burner dealer FIRST!
This propane gas power burner is designed to operate on propane gas ONLY, at a pressure regulated
at 11” (279.4mm) water column (W.C.) when equipped with the correct propane orifices on the valves
and a propane regulator on the supply line regulated at the residential meter. The LP gas power burner
is designed to be used with a standard 20 lbs gas cylinder and must be constructed and marked in
accordance with specifications of the US Department of Transportation for propane gas cylinders.
Always keep cylinder securely fastened in an upright position. Never connect an unregulated propane
gas cylinder to the power burner.
Do not subject propane cylinders to excessive heat.
CAUTION:
Never store a LP gas cylinder inside a building or in the vicinity of any gas-burning
appliance.
Cylinder Specifications
- Any L.P. gas supply cylinder used with this power burner must be
approximately 12 inches diameter and 18 inches high. The maximum
fuel capacity is 80% and is approximately 20 pounds of propane.
- The L.P. cylinder must have a shut-off valve (see picture) terminating
WARNING:
Never attach an unregulated gas line to the appliance. Connection to an
unregulated gas line can cause excessive heat or fire.
NOTE: Always have a qualified service technician perform difficult conversions
or modifications.
LP Gas Hook-up
Gas Requirements
Loading ...
Loading ...
Loading ...