Briggs & Stratton 020228 pressure washer

User Manual - Page 10

For 020228.

PDF File Manual, 36 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Section 4: Operation
8. Start engine according to instructions given in engine
owner's manuaLAHso see operating instructions tag
Hocated on the pressure washer,
When starting engine, pull cord slowiy undJ resistance is felt
and then pull rapidly to avoid kickback.
If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
NOTE: Always keep the throttle lever in the "Fast"
)osition when operating the pressure washer.
WARNING
DO NOT touch hot surfaces.
Allow equipment to cool before touching.
The pressure washer must be at least 5 feet from structures
having combustible wails and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for" adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code), Other"
states may have similar laws. Federal laws apply on federal
lands. If you equip the muffler" with a spark arrester, it must be
maintained in effective working order:
How to Sto Your Pressure Washer
I. Let engine idle for two minutes.
2. Turn engine off according to instructions given in
engine owner's manual,
3. Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid iniury.
NOTE: A small amount of water will squirt out when
pressure is released.
1
WARNING
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
Squeeze triter on spray gun to relieve trapped pressure,
every time you stop engine. Engage triter lock on spray gun.
4. Engage trigger lock on spray gun when not in use.
The unit is equipped with an accessory tray with places to
store your spray gun_ nozzle extension, turbo nozzle_ and
ProjectPro TM nozzles.There is also a hook at the front of
the accessory tray to hold your high pressure hose.
NOTE:The extra hole in the tray is for storing a utility
brush.The brush is NOT included with your pressure
washer.You can buy the brush as an optional accessory,
I. Place nozzle extension through hole on accessory tray,
as shown in Figure II.
2. Place spray gun through hole on accessory tray on
right side of unit (Figure II).
3. Push turbo nozzle up and into clip on accessory tray
until it snaps in, as shown in Figure I I.
4. Hang high pressure hose on hook attached to accessory
tray on front of tray, as shown in Figure I I.
Loading ...
Loading ...
Loading ...