Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Power cord not plugged in. Plug inpower cord.
Stops
No power at plug. Check electrical source or call
eIectrician.
Fuse blown or circuit Replace fuse or resetcircuit breaker.
breaker open. Ifproblem continues, calIeIectrician.
Using an extension cord. Do not use extension cords.
Timer is not lined up. Turn timer to the right slightly
and pull to start.
Timer knob not pulled out. Set and pullout knob.
Machine is overloaded. Wash smaller Ioads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator is much This is normal.
Too Low/Not higher than the highestwater
Completely level. This createsa perception
Filling of the washer not being fuIl.
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal,
Unit not level, Ensure front feet are installed and
nuts aretightened. Levelwasher.
Reset rear legs (see "Installation
Instructions,"Section G).
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color.
OverIoading. Lint can be trapped in load if
overIoaded. Wash smaller loads.
Paper or tissue in pockets. CIean outpockets before washing.
Not enough detergent. Use enough detergent to
hold lint in water.
Detergent not dissolving. Use wash water warmer than
Water temperature lowerthan 70° F (21° C).
70° F (21° C).
32
Loading ...
Loading ...
Loading ...