Loading ...
Loading ...
Loading ...
16
Convertible Display Shelves
Your wine cellar has two convertible display shelves - one in each
of the top two compartments. To use the display shelf, first
remove any wine bottles stored on the shelf. Next, remove the
wine shelf directly above (see Shelf Removal section). Lift the shelf
up, rotate the shelf support up and lock shelf into place with legs
(see illustration below).
Wood Facings
Maple wood facings are included with each shelf. These facings may be left unfinished, finished and sealed, or replaced with
other wood to match your cabinetry. Refer to the wine cellar installation instructions on how to replace the wood facings.
NOTE:
Some finishes may cause undesirable odors. The recommended procedure is to test a sample in the wine cellar on
scrap material before making permanent changes to wine cellar fronts.
Changing Light Tube (top zone)
To change the light tube, first remove the center grille
assembly and turn the power ON/OFF switch to the OFF
position (see the Before Using Your Wine Cellar section).
Control Panel
1. Remove the four screws from the lamp holder attaching the lamp holder to the underside of the control panel.
2. Rotate the rear of the lamp holder down and forward then pull the front tabs that engage into the control out of the control
panel.
3. Set the lamp holder and screws to the side.
4. Pull the wires attached to the lamp tube through the hole in the control panel and disconnect the wires attaching the lamp
to the cabinet wire harness.
5. The lamp tube is to be connected to one white wire and one yellow/red wire.
6. Place tubes in lamp holder. Feed wires back into control panel and reassemble in reverse order.
NOTE:
Please contact your parts distributor or dealer to order new light tubes.
Shelf
Support
Loading ...
Loading ...
Loading ...