Loading ...
Loading ...
Loading ...
Bevel
Angle
Settin£
33.85
33.85
33.85
33.85:
Type of Cut
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
3. Save right end of cut
CUTTING WARPED MATERIAL
See Figures 33 and 34.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against
the fence as shown in figure 33.
If the warped material is positioned the wrong way as
shown in figure 34, it will pinch the blade near the comple-
tion of the cut.
RIGHT
Fig. 33
WRONG Fig. 34
_, WARNING: To avoid a kickback and to avoid
serious personal injury, never position the concave
edge of bowed or warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 35.
When cutting wide workpieces such as a 2 in. x 6 in.,
boards should be clamped with a C-clamp as shown in
figure 35.
WIDE
BOARD
Fig. 35
28
Loading ...
Loading ...
Loading ...