Loading ...
Loading ...
Loading ...
Avoid Service ChecMist oo o°od
PROBLEM POSSIBLECAUSE/SOLUTION
RANGE DOES NOT OPERATE
Surface elements do not heat. NOpower to range. Check steps "Entire range does not operate" above.
Control knobs settoo low. At very low heat settings of tile control knobs, the surface signal
light may come on; however, surface unit does not operate. Turn tile control knob to a
slightly higher setting until the elements start heating.
Coil elements not seated properly in terminals. Turn temperature control knobs to 0% Pull
out and lift up coil elements. Straighten terminals on end of coil element if necessary.
Replace elements properly into the element block.
Incorrect surface control knob turned on. Make sure the correct surface control ison for tile
surface unit to be used.
Oven light does not work. Burned-out light bulb. See "Oven Lamp" in the "General Inforraation" section.
Control panel light does not oper_ Lamp loose in sockets or burned-out. See Fluorescent Lamp in General Information section.
ate (some models).
SURFACEUNITS
Surface elements too hot or too Raiseor lower setting until proper amount of heat is obtained.
cold.
Use only flat bottom, evenly balanced, medium or heavy-weight cookware. Pans having a
flat bottom heat better than warped pans. Cookware material affects heating. Heavy and
medium weight pans heat evenly. Because light-weight pans heat unevenly, foods may
burn easily.
Liquids boil at LOW setting of sur_ Incorrect setting of the control knob. Turn control knob to a lower setting.
face units.
Cooking on right rear element. When the oven isoperating, heated air escapesthrough the
oven vent located directly under the right rear end coil element or little behind it. This will
increase the heat input.
CERAMIC GLASS COOKTOP
(some models)
Scratches or abrasions on cooktop See "Ceramic Glass Cooktop" section in "General Information" section.
surface.
NOTE: Clean sugary food spills on the heating surfaces assoon aspossible, asthese can cause cratering of these surfaces when
hot.
31
Loading ...
Loading ...
Loading ...