Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
•
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the door. (See page 7.)
INSTALLATION OF YOUR APPLIANCE
•
The appliance is designed for free-standing or built-in installation
•
CAUTION: This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
•
Place your Beverage Cooler on a floor that is strong enough to support it when it is fully loaded. To
level the unit, adjust the front leveling legs.
•
For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the unit to
allow proper air circulation to cool the compressor and condenser. Even for built-in installation, it is a
must to keep ¼” (6.35mm) space on each side and at the top and 2” (51mm) at the rear. Take care that
the air vent at the front of the appliance is never covered or blocked in anyway.
•
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other
heating source. Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Don’t install in a location where the temperature will fall below 60°F (16°C).
For best performance, do not install the appliance behind a cabinet door or block the base grille.
•
Avoid locating the unit in moist areas.
•
Plug the Beverage Cooler into an exclusive, properly grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning
power and/or grounding should be directed toward a certified electrician or an authorized
service center.
•
NOTE: Model numbers with “OS” in their suffix feature reinforced construction and can be used in
the outdoors. Extreme temperature conditions may affect performance.
ELECTRICAL CONNECTION
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug that mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the
appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the receptacle.
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use
a cord that shows cracks or abrasion damage along its length or at either end. When moving the appliance,
be careful not to damage the power cord.
Loading ...
Loading ...
Loading ...