Loading ...
Loading ...
Loading ...
26
Control Panel
DO NOT use any cleaners containing ammonia or abrasives. They could remove the graphics from the control panel. Use
hot, soapy water and a soft clean cloth.
Oven Surfaces
Several different finishes have been used in your oven.
NEVER USE AMMONIA, STEEL WOOL PADS OR ABRASIVE CLOTHS, CLEANSERS, OVEN CLEANERS, OR ABRASIVE
POWDERS. THEY CAN PERMANENTLY DAMAGE YOUR OVEN.
Self-Clean
Your oven features a self-clean cycle for the oven interior.
See the "Self-Clean Cycle" section for complete instructions.
Cleaning and Maintenance
Control Knobs
MAKE SURE ALL THE CONTROL KNOBS POINT TO THE OFF POSITION BEFORE REMOVING. Pull the knobs straight off.
Wash in detergent and warm water. Dry completely and replace by pushing firmly onto stem. DO NOT use any cleaners
containing ammonia or abrasives. They could remove the graphics from the knob.
Stainless Steel Parts
All stainless steel body parts should be wiped regularly with hot soapy water at the end of each cooling period and with a liquid
cleaner designed for that material when soapy water will not do the job. DO NOT use steel wool, abrasive cloths, cleansers, or
powders. If necessary, scrape stainless steel to remove encrusted materials, soak the area with hot towels to loosen the material,
then use a wooden or nylon spatula or scraper. DO NOT use a metal knife, spatula, or any other metal tool to scrape stainless
steel. DO NOT permit citrus or tomato juice to remain on stainless steel surface, as citric acid will permanently discolor stainless
steel. Wipe up any spills immediately.
Glass Surfaces
Clean with detergent and warm water. Glass cleaner can be used to remove fingerprints. If using glass cleaner ammonia,
make sure that it does not run down on exterior door surface.
Oven Racks
Clean with detergent and hot water. Stubborn spots can be scoured with a soap-filled steel wool pad.
Problem
Cause To Prevent To Remove
Metal markings
silver/gray marks
Sliding or scraping metal utensils
on glasstop.
DO NOT slide metal objects
across top.
Remove metal marks before the
glasstop is used again. Apply
cleaning cream with a damp
paper towel and scrub with a
nylon scrub pad or
brush. Rinse thoroughly and
dry.
Hard water spots
Condensation from cooking may
cause minerals found in water
and acids to drip on glasstop and
cause gray deposits. The
spots are often so thin they
appear to be in or the glasstop.
Make sure the bottom of utensils
are dry before cooking. Daily
use of cleaning cream will help
keep top free
from hard water mineral deposits
and food discoloration.
Mix cleaning cream with water
and apply a thick paste to
stained area. Scrub vigorously.
If stain is not removed, reapply
cleaner and repeat process. Also
try cleaning procedure for
smearing and streaking.
Pitting or flaking Boil over of sugar syrup on
glasstop. This can cause pitting if
not removed immediately.
Watch sugar and syrups carefully
to avoid boilovers.
Turn element to LO; using
several paper towels to wipe the
spill immediately. Let glasstop
cool and carefully scrape off
remainder of burn-off with a
single edged razor held at a 30°
angle.
Cleaning Problems on Glass Ceramic Top (cont.)
Loading ...
Loading ...
Loading ...