Bosch SMU50E65AU Dishwasher

Operating Instructions - Page 14

For SMU50E65AU.

PDF File Manual, 26 pages, Read Online | Download pdf file

SMU50E65AU photo
Loading ...
Loading ...
Loading ...
aus
14
Programme data
The programme data (consumption
values) can be found in the summary of
instructions. They refer to normal
conditions and the water hardness set
value :‹…. Different influencing factors
such as e.g. water temperature or line
pressure may result in deviations.
Aqua sensor
Aqua sensor *
* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
“clean” rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 3–6 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted to
the degree of soiling.
Switching on the appliance
Turn on the tap fully.
–Switch on ON/OFF switch (.
Rotate programme selector 8 to the
required programme.
The expected programme duration
flashes on the digital display H.
Press START button @.
The programme starts running.
Remaining running time display
When the programme is selected, the
remaining running time of the programme
is indicated on the digital display H.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
Timer programmin g
Timer programming *
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
Close the door.
–Switch on ON/OFF switch (.
Press button P until the digital
display H jumps to œ:‹‚.
Press button P until the displayed
time corresponds with your
requirements.
Press START button @, timer
programming is activated.
To delete the preselected starting time,
press the button P until œ is
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value :‹‹ is indicated on the numerical
display H.
Swit ching off automatic all y after the end of the programme
Switching off automatically after
the end of the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from ˜:‹‹ to ˜:‹ƒ.
Close the door.
–Switch on ON/OFF switch(.
Press and hold down the START
button @.
Rotate programme selector 8
until ˜:... s indicated on the digital
display H.
Release button.
The factory set value ˜:‹‚ is lit on the
digital display H.
Washing the dishes
˜:‹‹ Appliance does not switch off
automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
Loading ...
Loading ...
Loading ...