Loading ...
Loading ...
Loading ...
11
Customer Care Center, 1-800-898-1879, www.askousa.com
have installed a hidden helper between the two
appliances, then binding plates are available as
optional accessories at the service unit.
A
B
Built-in installation
ASKO washers can be installed beneath a cabinet
or worktop with a height of 34” to 35” (863 to 889
mm) or in a closet. There must be a gap of about ½”
(12 mm) all around the machine, including between
the rear edge of the machine’s top panel and the
back wall. The opening width must be at least
24½” (622 mm). Space must also be available for
the fi ll and drain hoses. See the illustration below
for measurements and positions. If the washer is
installed in a closet the door must be left open while
the washer is running.
622 mm
If the drain outlet is higher than 24"(610 mm), the
connections will need to be recessed.
ADJUSTING THE FEET
Place the washing machine so that it is stable.
It is important that the machine is level to prevent
excessive vibrations during spin cycles. Each foot
of the washer is adjustable, so you can level the
washer on any surface. Once it is level, securely
tighten the lock nuts on the feet to prevent excessive
vibration during spin cycles.
1. Level the washing machine in longitudinal and
traverse direction by rotating the adjustable feet.
The feet allow levelling by +/- 1 cm.
2. When the appropriate height of feet is set, use the
wrench No. 17 to fi rmly fasten the counter-nuts
towards the bottom of the appliance .
3. Tighten the jam nuts (counter nuts) to the end
position.
This will reduce washing machine noise to
minimum.
1
2
3
Loading ...
Loading ...
Loading ...