Loading ...
Loading ...
Loading ...
To Level The Refrigerator:
While unit is lyingon its back, note the
location of the 4 leg levelers installed at
each corner. These leg levelers will be
iiiiiiiiiiiiiiii!}ii:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i!_!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
iiiiiiiiiiiiiiiiiiiiiii!}ii:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i
iiiiiiiiiiiiiiiiiiiiiiiiii!}ii:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:i
iii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii::
_hs_s_s_s_s_s_s_s_s_s_s_s_s_
used to level the refrigerator and to adjust
the height. Use a carpenter's level to level
the refrigerator from front to back and side
to side. Adjust the plastic leveling feet in
front, 1/2bubble higher, so that the door
closes easily when left halfway open.
Plastic
Leveling Feet (
c_
Leveling Instructions For
Matching Tall Refrigerator / Tall
Freezer Pair:
• Level door of first unit using all four
levelers and slide unit into place.
Recheck for levelness and adjust
if necessary.
Measure distance from floor to
bottom of door on first unit. Adjust
and level second unit so door
height matches.
• Leg Level Adjustments:
One full turn of all four leg levelers will
raise door 5/32".
Leveling Door with
Adjustable Hinge
Use the lower hinge adjustment to fine
tune the door height and for final cabinet
spacing. Use a 7/16" socket or wrench
to adjust the screw at the bottom of the
lower hinge.
Adjusting Doors For Matching Tall
Refrigerator / Tall Freezer Pair
The doors may also be adjusted side to
side with the slotted hinge for aligning
the doors parallel to each other. Loosen
the two bolts with a %" wrench and one
screw with a Phillips screwdriver. Shift
the doors until parallel, then retighten the
screws securely. (See illustration below.)
Lower Hinge Adjustment For
Leveling The Doors Of The
Matching Tall Refrigerator / Tall
Freezer Pair
To level the doors using the adjustable
lower hinge (some models):
1. If the refrigerator door is lower than
the freezer door, raise the refrigerator
door by turning the adjustment screw
clockwise using a 7/16" socket
wrench. (See illustration below.)
2. If the freezer door is lower than the
refrigerator door, raise the freezer
door by turning the adjustment screw
clockwise using a 7/16" socket
wrench. (See illustration below.)
Slide second unit into place leaving a
minimum gap of 3/16" between units
for door swing clearance.
This last step may require at least
one extraction of the second
unit to properly align units in a
"built-in" application.
Loading ...
Loading ...
Loading ...