Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
Operating the DUAL Surface Elements
The cooktops are equipped with a DUAL radiant surface
element located at the right front cooktop position (Figures 1
& 2). Indicator lights on the control panel at that position are
used to indicate what portions of the dual radiant element will
heat. The INNER light indicates that only the inner element
will heat. The OUTER light indicates that both inner and
outer elements will heat together. You may switch between
these different settings at any time during cooking.
To Operate the Dual Surface Elements:
1. Place correctly sized cookware on the radiant surface
element.
2. Touch and hold the _ key pad until a beep sounds.
The power indicator light will turn ON. Note: If no key
pad is touched within 20 seconds the request to Power
ON the cooktop will clear.
3. Touch and hold the (o_i}o_pad for the dual element
position until a beep is heard. The display will show "- -"
Note: If no further pads are touched within 10 seconds
the request to power the element ON will clear.
4. Select the INNER (Figure 3) or OUTER (both elements)
(Figure 4) to heat by pressing the _i'_men_pad once or
k, Sizej_,
twice (Figures 4 & 5 show indicator lights with OUTER
Figure 1
• 0 Outer
® Inner
Figure 3
\/ Lo
00ut_:r
(®) Q k_rer
[]ement
Figure 5
and INNER elements selected). Note: If no element size is chosen when the dual element is turned ON, the control
will default to the inner coil only.
5. Touch HI pad once to turn ON the power level to HI (See Figure 5). Touch Lo pad once for Lo.
6.
7.
8.
Each touch of the HI or pad will decrease or increase the power level from 9.5 through 3.0 by .5
increments. Simmer power levels between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest
power level available.
Note: The power level may be adjusted at any time while the element is ON.
Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. Each surface
element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond
the bottom edge of the cookware indicates the cookware is too small for the surface heating area.
............ %
When cooking has been completed touch the oo/of_#pad once to turn the element OFF and if no other surface
element is used touch the _ key pad to turn off the cooktop.
Note: The HE (hot element) message will remain ON if the cooktop is still hot and will remain ON until the heating
surface area has cooled sufficiently.
........!i:.....
Warm & Hold Feature
The Warm & Hold feature may be used with any of the Cooking Elements.
To Turn the Warm & Hold Feature ON:
1. To select the Warm & Hold feature for any Cooking Element touch the oo/off_key pad for the
corresponding Cooking Element. Fig.6
Touch the _ key pad located in the main control area. The associated display will show LH (low heat
2.
Fig. 6)
i
indicating that the Cooking Element is properly set to Warm & Hold. If no other key pads are pressed the control will
activate the desired Cooking Element at the Warm & Hold setting.
11
Loading ...
Loading ...
Loading ...