Loading ...
Loading ...
Loading ...
CHECKING
YOURVENT
Your dryer must be properly installed and vented to
achieve maximum drying efficiency and shorten drying
times. Use the minimum recommended installation
clearances (found in your Installation Instructions) to
avoid blocking the flow of combustion and ventilation
air. Refer to your installation Instructions for more
information.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in
death or fire.
If the dryer is not properly installed and vented, it will not
be covered under the warranty.
NOTE: Service calls caused by improper venting will be
paid for by the customer, whether it was a paid installation
or self-installed.
1. Do not use plastic vent or metal foil vent. Use 4 in(10.2
cm) metal or flexible metal vent must be used. Do not
kink or crush flexible metal vent. It must be completely
extended to allow adequate exhaust air to flow. Check
vent after installation. Refer to your Installation
instructions for proper length requirements of vent.
2. Use a 4 in (10.2 cm) exhaust hood. Smaller hoods
increase drying times.
(10.2 cm)
3. The exhaust vent can be routed up, down, left, ri(
straight out the back of the dryer. Space requiren
are listed in your Installation Instructions.
4. Use the straightest path possible when routing th_
exhaust vent. Use the fewest number of elbows ar
turns. Allow room when using elbows or making tL
Bend vent gradually to avoid kinking.
UJ
5. Use duct tape to seal ell joints. Do not use screws t
secure vent. Lint may catch on screws.
6, Clean exhaust vent periodically, depending on use, b_
at least every 2 years, or when installing your dryer in
new location.
• Disconnect vent from the dryer and clean one
section at a time until you reach the exhaust hood
• Use the hose attachment on your vacuum, or a pol_
or wire with a feather duster or rag attached, to
clean out lint.
a Be sure the flapper on the outside end of vent
moves freely.
When cleaning iscomplete, be sure to follow the
installation Instructions supplied with your dryer for
final product check.
6
Loading ...
Loading ...
Loading ...