Loading ...
Loading ...
Loading ...
4. Place Guide Bar over Guide Bar Studs, NOTE:BAR GOES
ON ONLY ONE WAY--NOTE CONTOUR OF BAR (FIG.
4)° ALSO, THE SMALL ROUND HOLE COMPLETELY
THRU THE BAR IS BELOW BAR SLOT.
5, Hold Guide Bar slightly away from the Saw Frame., Push
_Baras far TOWARD the Chain Sprocket asit will go. Place
Chain Drive Links around Chain Sprocket and in Guide Bar
groove (Fig. 5), SHARP EDGES OF CUTTERS MOVE
AWAY FROM THE SAW FRAME ON TOP OF THE
GUIDE BAR (FIGo 5- INSET),
B, Place Outer Chain Guide on Guide Bar Studs with upper
and lower edges bent AWAY from the Saw Frame (Fig,,
6-A) o
7. (Fig. 6). Push Guide Bar against Saw Frame. (Fig. 6-A)o
Hole in Guide Bar should be centered in slot of Outer Chain
Guide It may be necessary to pull Bar forward.
8o (Fig., 6-B)o Center Chain Tightener Block Pin in Slot of
Chain Shield. To do this, turn Chain Tension Adjusting
Screw,
go (Fig° 6), Place Chain Shield onto Guide Bar Studs, Holding
Chain Shield to Frame, turn Saw on its side (Fig. 6-C)_
Chain Tightener Block Pin must be in Hole of Guide Bar,
in order to tension Chain (Page4).
10. Set Saw upright (Fig° 7), Assemble Chain Shield to Saw
Frame with Guide Bar Nuts_ Assemble Machine Screw in
rear corner of Chain Shiel& NOTE: Tighten Machine Screw
securely, Tighten Guide Bar Nuts FINGER TIGHT ONLY.
GUIDE BAR
ROUND GUIDE
HOLE BAR
CHAIN SPROCKETI
GUIDE
BAR
.FIGURE 4
CHAIN
TRAVEl
DRIVE'
LINKS
FIGURE 5
FIGURE
CHAIN
GUIDE
GUIDE BAR HOLE
CHAIN
SHIELD
CHAIN TENSION
ADJ USTI N G
SCREW
GUIDE BAR
SAW
GUIDE BAR
FIGURE 6
VIEW OF SAW ON
ITS LEFT HAND
SIDE LOOKING UP
TO BOTTOM OF
CHAIN SHIELD.
'tGHTENEB
PIN
GUIDE
BAR
FIGURE 6C
CHAIN
TENSION
ADJUSTING
CHAIN
TIGHTE
BLOCK PIN
SHIEL[
SLOT
-3-
Loading ...
Loading ...
Loading ...