Loading ...
Loading ...
Loading ...
12
http://www.NewAir.com
working, the compressor will be getting hot. If you add water into the unit after
the unit has been running for more than an hour, the water will cool the
compressor so it uses less power.
The Efficiency Booster feature is meant to be used after one hour of usage and
the water should NOT be over 2.5 pints (1.2L). Otherwise, the “water full”
indicator light will light up and the unit will stop working.
If the Water Full indicator is on, please drain water from the port on the back
side of the unit until the light turns off. The unit will work again now.
DRAINING THE UNIT
When the unit is operating in Cooling or Dry mode, humidity extracted from
the air is collected in an internal tank. If the tank reaches full, the
compressor and motor cut out automatically. At the same time, the “Water
Full” indicator comes on. An alarm will also sound. When the tank is full,
carry out the following instructions:
Turn off the air conditioner and
avoid moving it when full.
Position a container (a water
tray for example) underneath
the drain hole.
Remove the drain knob &
rubber plug from the drain hole
and allow the water to drain out.
When the container is almost
full, replace the rubber plug in
the drain hole and empty the water tray.
Repeat until the unit is emptied.
Replace the rubber plug and tighten the drain knob firmly.
Switch on the unit - the full water or compressor operating indicator
should
not be flashing.
Loading ...
Loading ...
Loading ...