Loading ...
Loading ...
Loading ...
Your condenser tumble dryer removes humidity by using two separate air flows. Air re-
circulates inside the machine and is heated. Then it is passed through the damp clothes
where it picks up moisture. Damp air is passed through the condenser in one direction
while the room air is passed through the condenser in the other direction. This causes
the moisture in the air to condense into water which is then pumped to the water tank
or out through the hose.
For convenience, dryers are often positioned close to the washing machine, so the
laundry can be easily transferred. The tumble dryer will expel some moist air, so make
sure the room is well ventilated. Install the dryer in a clean environment, and make sure
there are no obstructions around any vents. It should be placed on a firm level surface,
this helps keep noise and vibration to a minimum.
For the dryer to work with less noise and vibration, it must be stable and balanced on its
feet. There should be no movement from the dryer. Adjust the feet underneath the
dryer to make sure it is completely stable. Rotate the feet to the right and to the left
until the dryer is even and stable.
If installing the dryer under a counter you must leave 3cm of space between the side
and rear walls of the product and the underside of the worktop
Do not install the tumble dryer in a room when there is a risk of frost occurring. At
temperatures around freezing point the tumble dryer may not be able to operate
properly. There is a risk of damage if the condensed water is allowed to freeze in the
pump, hoses and condensed water container. The tumble dryer works best in a room
between 5°c and 35°c.
In products equipped with a condenser unit the water accumulated during the drying
cycle is collected in the water tank. For the dryer to operate at optimum efficiency the
water tank should be emptied after every drying cycle. Alternative you can directly send
the accumulated water out through the water drain hose supplied with the machine
instead of emptying the water tank after each drying cycle.
NOTE: when cleaning the condenser unit you will notice that an amount of water will be
in the tray it has just been removed from. This is expected and normal, this is where the
hot air is condensed and the water is then pumped to the water tank.
Installation
11
Loading ...
Loading ...
Loading ...