Loading ...
Loading ...
Loading ...
6.1 IDENTIFICATION
Outlet.
Carry handle.
Integral float switch.
Filter base plate.
Hose adaptor.
9. INSTALLING THE PUMP
6. TECHNICAL DESCRIPTION
9.3 SET CUT OFF FLOAT HEIGHT
FIG. 7
The float switch can be set to a specific cut off
level by increasing or decreasing the length of
cable % between the cable clamp recess
& and float switch .
9.4 SET INTEGRAL FLOAT HEIGHT FIG. 8 (Stock No. 98917& 98918 only)
An integral float switch is fitted to the pump,
this enables the pump to switch off
automatically when the water has reached
the minimum level. To enable the float
switch ensure the mode selection lever is
pushed down to Auto.
As the water level drops the float switch will
fall with the water level. The minimum level
can be changed by pinching the levers
together and raise or lower to desired level.
When the float switch reaches the minimum
level it will automatically switch the pump
off.
This pump can also be run in a continuous
mode by pulling the mode selection lever up
so it indicates on the side of the pump
Manual. The pump should not be left
unattended at any time, to ensure the pump
does not run dry.
6.2 MAIN COMPONENT DESCRIPTIONS
The CARRY HANDLE for ease of transportation.
The HOSE ADAPTOR allows the use of different size hoses.
The WATER OUTLET; Pumped water is expelled from this aperture.
The PLUG connects the machine to your power supply.
The FLOAT SWITCH will switch the pump on/off automatically at set water levels (user
adjustable).
The MAIN PUMP BODY houses the pumps motor, it should be submerged in use to help cool
the motor.
The INLET/IMPELLER HOUSING; This is where the water to be pumped enters the machine.
The impeller is mounted in the top section of the housing.
%
&
FIG.7
FIG.8
Stock No. 98917 shown.
- 15 -
- 10 -
Loading ...
Loading ...
Loading ...