User Manual Barclay 3854WH White Bath Sink

Documents for Barclay 3854WH

The following documents are available:
User Manual Other Documents
  • Stanford 600 Pedestal - (English) Download
Photos
3854WH photo

User Manual

For 3854WH.

Pedestal Lavatory For: Lavatory Basins
Without Hangers
INSTALLATION INSTRUCTIONS
P 847•244•1234 www.barclayproducts.com
4/4/12
Tools Needed
Level Screwdriver Pencil Drill & Bits Wrench 2 Molly Bolts, Toggle Bolts, or Lag Screws (depending on wall)
NOTE:
DO NOT tighten too much or you may damage bowl.
1. Place lavatory bowl on pedestal so back of bowl is flat against the wall.
2. Adjust the bowl so it fits as snugly as possible to the pedestal and is straight when checked with a level
placed at the back of the bowl.
3. Check under the bowl for two holes. With a pencil, mark the location of these holes on the wall.
4. At the base of the pedestal there may be either one or two holes. If there are holes, mark their position on
the floor.
5. Remove bowl from the pedestal being careful not to move pedestal. Before replacing bowl, it would be
convenient at this point to mount the faucet according to the manufacturer’s instructions.
6. Start to drill hole
through the 2”x12” re-inforced wall for molly bolts or toggle bolt. If drill bit hits a stud, stop
immediately. Attach the bowl to the wall with lag screws.
7. If molly bolts are used, install and expand the bolt holders. Insert the bolts through the holes in the bowl and
thread into the expanded portion already in the wall.
8. If toggle bolts are used, make holes large enough to accept collapsible wing nut bolt but do not insert bolts
into hole. Push collapsed wing nuts through the holes in the bowl and through the holes in the wall.
9. Place the bowl on the pedestal. Make sure that the holes in the bowl line up with the holes drilled in the wall.
10. Attach pedestal to floor using either a long screw or lag bolt. DO NOT TIGHTEN TOO MUCH. The only
purpose of securing the base to the floor is to prevent the pedestal from being “kicked out” from under the bowl.
11. Connect all supply tubes to the faucet. Connect trap and drain assembly as described by the manufacturer.
12. If there is a gap between the bowl and pedestal, apply a bead of white latex caulking at the junction of the
two pieces.
Be sure to re-inforce wall before
installation. We recommend a
2”x12” securely fastened to wall
studs at the required height for
your installation.