Loading ...
Loading ...
Loading ...
UNPACK CARTON & INSTALL
HANDLE
_CAUTION: Be careful of exposed
staples when handling or disposing of
cartoning material.
IMPORTANT: When unpacking and
assembling tiller, be careful not to stretch
or kink cable(s).
1. Cut cable ties securing handle
column.
2. Route cable(s) as shown and slide
handle column onto handle mount.
3. Remove all packing from carton.
4. Secure handle column using two (2)
carriage bolts and two (2) flange
Iocknuts. Tighten securely.
5. Cut away carton.
6. Route tine control cable(s) through
plastic cable clip on handle mount.
NOTE: Cables must not touch the muffler.
7. Cut cable ties securing tiller to skid.
Remove tiller from skid by pulling
backwards.
8. Remove screws securing depth stake
to skid and discard the screws.
Handle Tine ' 7"J
M°unt_ C°! Itr°I/-- -Handl_"e
Oo,umn
N _ -Flange
Locknut
INSTALL DEPTH STAKE ASSEMBLY
1. Loosen nut "A".
2. Insert stake support between engine
bracket halves with stake spring
down.
3. Bolt stake support to engine brackets
with bolts, lock washers and nuts.
Tighten securely. Tighten nut "A".
4. Depth stake must move freely. If it
does not, loosen support bolt.
-'ngine Bracket Halves
Nut "A" Depth
Stake
Support
Bolt
Stake Spring
Hex Bolts, Lock Washers,
and hex Nuts
HANDLE HEIGHT
• Handle height may be adjusted to
better suit operator. (See "HANDLE
HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better
handle your tilling conditions (See
"-I'INE ARRANGEMENT" in the Service
and Adjustments section of this
manual).
TINE OPERATION
• Check tine operation before first use.
(See "TINE OPERATION CHECK" in
the Service and Adjustments section of
this manual).
6
Loading ...
Loading ...
Loading ...