Loading ...
Loading ...
Loading ...
_rminal
INSTALL SEAT
Adjust seat before tighteningadjustment
knob.
1. Remove adjustmentknob and flat
washer securing seat to cardboard
packingand set aside for assembly of
seat totractor,
2. Pivot seat upwardand remove from
the cardboard packing, Remove the
cardboard packing and discard.
3. Place seat on seat pan so head of
shoulderbolt is positioned over large
stotted hole in pan.
4. Push down on seat to engage
shoulderbolt in slot and pull seat
towardsrear of tractor.
5. Pivot seat and pan forward and
assemble adjustment knob and flat
washer loosely. Do not tighten.
6, Lower seat into operating positionand
sit in seat.
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat without moving its
adjusted position.
9. Raise seat and tighten adjustment
knob securely.
Seat
Bo]t
FiatWasher
AdjustmentKnob=p B
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press liftlever plunger and raise
attachment lift lever to its highest
position.
2. Release parking brake by depressing
clutclVbrake pedal.
3. Place gearshift lever in neutral (N)
position.
4. Roll tractor forward off skid.
5. Remove banding holding deflector
shield up against tractor.
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
_I,WARNING: Before starting, read,
understand and follow all instructions in
the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be
sure the area in front of tractor is clear of
other people and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fill fuel tank
with gasolina.
3. Sit on seat in operating position,
depress clutch/brake pedal and set
the parking brake.
4. Place gear shift lever in neutral (N)
position.
5. Press lift lever plunger and raise
attachment lift lever to its highest
position.
6. Start the engine. After engine has
started, move throttle control to idle
position.
7. Depress clutch/brake pedal into lull
"BRAKE" position and hold. Move
gearshift lever to tst gear.
8. Slowly release clutch/brake pedal and
s]owly drive tractoroff skid.
9. Apply brake to stop tractor, set parking
brake and place gearshift lever in
neutral position.
lO.Tum ignition key to "OFF" position.
Continue with the instructions that follow.
Loading ...
Loading ...
Loading ...