Loading ...
Loading ...
Loading ...
Installation Instructions
[] TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
[] PLUG IN THE REFRIGERATOR
Arrange tile coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the w_all.Push the refrigerator back to the w_all.
[] START THE ICEMAKER
On power switch models, set the icemaker power
switch to the ! (on) position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically.
Powerswitchmodel
STOP (up} position
rArmin
theON{down)position
Feelerarmmodel
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
IFJIREVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are fbr changing the hinges fl'om
the right side to the left side--if you ever want to
change tile hinges back to the right side, follow these
same instructions and reverse all references to left
and right.
TOOLS REQUIRED
Phillips screwdriver
5/16" hex-head
socket driver
Putty knifie or thin-
blade screwdriver
Masking tape
T20 or T25
Torxdriveg
(needed fbr
some models)
5/16" openmnd
wrench
15
Loading ...
Loading ...
Loading ...