Loading ...
Loading ...
First Steps (continued)
! 3"
Installation
Figure i
,.j._l SCREWS
t tl_ i HINGE COVER
"_ _._ ._
Figure2
8
P_
Door Removal (upright models)
If door must be removed to fit through narrow doorways.
1, Gently lay freezer on its back on a throw rug or blanket
2, Remove the base panel by unscrewing two screws from front of base panel
Remove wire from clips on bottom of cabinet (Figure 1)
3. Unplug connector by holding the cabinet connector in place and pulling door
connector out (Figure t)
4., At the top of the cabinet, lift up plastic hinge cover and fold back, (Figure 2)
5 Use a Phillips® screwdriver to loosen and retighten the screws on the top
hinge to insure a secure assembly and prevent hinge slippage
6 Remove the top hinge from cabinet and lift door off the lower hinge pin
7, After door is removed, remove the two screws from the bottom hinge
8, To replace door, reverse above order
Door Adjustments (upright models)
If door gasket does not sea!
1 Loosen all door panel screws around the edge of door (Figure 3) On 9 cubic
foot models, slam door to realign to cabinet, retighten all door panel screws
2 On larger models adjust the two screws on the bottom edge of door. (Figure4)
= If door does not seal on the top, follow illustrationA
o If the door does not seal on the bottom, follow illustration B
3 After adjustment, retighten all of the door panel screws
Ii_ ............DOOR GASKET
/_"i---.
//;//!1 "'_DOOR PANEL
!_ SCREWS
Figure3
A
LOOSEN
TIGHTEN
Figure 4
TIGHTEN
F=
Cleaning
,, Wash any removable parts, and the interior and exterior with mild detergent
and warm water Wipe dry
o DO NOT USE HARSH CLEANERS ON THESE SURFACES.
Do not use razor blades or other sharp instruments which can scratch the
appliance surface when removing adhesive labels. Any glue left from the tape
or energy label can be removed with a mixture of warm water and mild
detergent or touch the residue with the sticky side of tape already removed,
DO NOT REMOVE THE SERIAL PLATE.
Loading ...
Loading ...
Loading ...