Loading ...
Loading ...
Loading ...
5
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote Troubleshooting
Check the outlet box:
Installing the Ceiling Bracket
Installing the Downrod
You have two options for installation. Pick which one works best for your location.
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
Use wood screws (included)
when securing to support
structure with approved
electrical outlet box. Drill
9/64” pilot holes in support
structure to aid in securing
ceiling bracket with
hardware found in the
hardware bag.
Use machine screws (pro-
vided with outlet box) when
securing to existing ceiling
fan-rated outlet box. Make
sure it is securely installed
and is acceptable for fan
support of 31.8 kg (70 lbs)
or less.
Option 2:
Wood Screws
Option 1:
Machine Screws
OFF
Turn Power
Do this rst!
The machine screws are the ones
that came with your outlet box.
Hunter Pro Tip:
8”
3/8”
C
U
T
&
S
T
R
I
P
(not to scale)
Hand tighten the downrod (at least
4-5 full turns) until it stops. Trim
the wires coming from the fan so
that 8-inches remain coming from
the top of the downrod.
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
K
E
E
P
!
For angled ceilings,
point opening
toward peak.
ANGLED
MOUNTING TIP
bag
2
3
1
STEP
STEP
STEP
Wood Screw
Washer
x2
x2
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
WARNING
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
Loading ...
Loading ...
Loading ...