Loading ...
Loading ...
Loading ...
2a)DuringchargingthegreenLEDwillappear.
2b)WhenchargingiscompletethegreenLEDwillgooff.
3. Unplugcharger,andremovethebatterypack.Placethebattery
pack into the tool until it "clicks" into place.
NOTE: To remove the battery pack, press down on the release
button on the back of the battery pack and slide out (figure 3).
1. After normal usage, your battery pack should be fully charged in
6 to 9 hours. If the battery pack is run-down completely, it may
take up to 9 hours to become fully charged. Your battery pack
was sent from the factory in an uncharged condition. Before
attempting to use it, it must be charged for at least 9 hours.
2. DO NOT charge the battery pack in an air temperature below
+40°F(+4.5°C), or above +105°F (+40.5°C). This is important
and will prevent serious damage to the battery pack. Longest life
and best performance can be obtained if battery pack is charged
when air temperature is about 75°F (24°C).
3. While charging, thecharger mayhum and become warm totouch. This
isanormal conditionand doesnot indicatea problem.
4. If the battery pack does not charge properly--(1) Check current
at receptacle by plugging in a lamp or other appliance. (2)
Check to see if receptacle is connected to a light switch which
turns power off when you turn out the lights. (3) Move charger
and battery pack to a surrounding air temperature of 40°F
(+4.5°C) to 105°F (+40.5°C). (4) If the receptacle and
temperature are OK, and you do not get proper charging, take or
send the battery pack and charger to your local Black & Decker
service center. See Tools Electric in yellow pages.
5. The batterypack should be recharged whenitfails to produce sufficient
power on jobs whichwere easilydone previously.DO NOT CONTINUE
using unitwith itsbattery pack ina depletedcondition.
6. The battery pack will reach optimum performance after being
cycled 5 times during normal usage. There is no need to run the
battery pack down completely before recharging. Normal usage
isthe best method of discharging and recharging the battery pack.
1. Store toot:
a.) with the battery pack removed and on the charger.
b.) in aplace thatiscool and dry awayfrom directsunlightand excess
heator cold.
c.) out of the reach of children.
2. For prolonged storage such as over the winter, the battery pack
should be fully charged and then removed from the charger. It
should be charged again just prior to use.
LEAVING THE BATTERY PACK IN THE CHARGER
Itis OK to leave battery packs on charge for long periods of time. The
charger has a maintenance mode which gives the battery pack
enough charge to stay "topped off". If however, the tool is not
expected to be needed for more than 30 days, unplug the charger
and store battery pack in a cool, dry location. NOTE: A battery pack
wilt lose its charge when kept off of the charger. If the battery pack
has not been kept on maintenance charge, it may need to be
recharged before use. A battery pack may also lose its charge if left
in a charger that is not plugged into an appropriate AC source.
TO INSTALL BATTERY PACK:
Insert battery pack into tool until an audible click is heard (figure C).
Make sure battery pack is fully
seated and fully latched into position.
TO REMOVE BATTERY PACK:
Depress the battery release button
in the back of the battery pack and
pull battery pack out of tool.
Loading ...
Loading ...
Loading ...