Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
= Electrical connection
•Do not use an extension cord or double adapter
•If the supply cord is damaged, itmust be replaced by a qualified person in order to avoid a hazard
•If the machine will not be used for an extended time, unplug it and shut off the water supply
•Connect the machine to a grounded outlet in accordance with current wiring regulations
•The appffance must be positioned so that the plug is easily accessible
= Connecting water supply hose
Hot watertap_..__,_
/ "_'__ V/// water
•Water supply pressure must be between
4 5 and 145 PSI (30-1000 kPa).
-Do not crossthread when connecting inlet hose to
the valve.
• tfthe water supply pressure is more than 145 PSI,
a pressure reducing device should be installed.
•Two Sealing washers are supplied withthe water
inlet hoses to prevent water leaks
•Check forleakage of washing machine connections
by turning the tap completely on.
• Periodicafly check the condition of the hose and
replace the hose if necessary
• Make sure thatthere isno kink in the hose and that
itis not crushed
. Be sure that the two water input ports are connected
to the correct water faucets. The connector for hot
water is colored red
_0"1 E: Washing Machine is to be connected te the water mains using new heseso
O|d hoses should not be used.
Repairs to the washing machine most only be carried out by qualified personnel, Repairs carried out by
inexperienced persons may cause injury or serinus maffunctionlng. Contact your local service center.
Do not install your washing machine in a room where temperatnres below freezing may occur.
Frozen hoses may burst under pressure_ The reliability of the electronic control unit may he impaired
at temperatures below the freezing polnL
If the appliance is delivered in the winter months aml temperatures are below freezing,
store the washing machine at room temperature fnr a few hours before putting it into operation.
7
Loading ...
Loading ...
Loading ...