Loading ...
Loading ...
Loading ...
• Cleantheinside of the cover and the
collar to remove any dirt accumutation.
• Insert new filter into cover.
• Put air filter cover and filter into collar
aligning the tab with the slot.
• Push in on cover and turn clockwise to
tighten.
Clip Tum
counter--
Slot
remove
to tighten
Airfilter cover
MUFFLER
Inspect and replace corroded muffler as it
could create afire hazard and/or damage.
SPARK PLUG
Change your spark plug each year to
make your engine start easier and run
better. Set spark plug gap at .030 inch.
CLEANING
IMPORTANT: For best performance, k_
mower housing free of built---up grass s
trash. Clean.underside of mower housin
after each use.
_h, CAUTION: Disconnect spark plug
from spark plug and place wire where it
cannot come in contact with the spark
plug.
• Turn lawn mower on its side. Make st
air filter and carburetor are up. Clean
underside of your lawn mower by
scraping to remove build--up of gras
and trash.
• Clean engine often to keep trash fren.
accumulating. A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels fr,
of all gasoJine, oil, etc.
• we DO NOT recommend using a
garden hose to clean lawn mower
unless the electrical system, muffler,
filter and carburetor are covered to k_
water out. Water in engine can result
shortened engine life,
_,CAUTION: Before performing any
service or adjustments:
• Release control bar and stop engine.
• Make sure the blade and all moving
parts have completely stopped.
• Disconnect spark plug wire from spark
plug and place where it cannot come in
contact with plug.
LAWN MOWER
TO ADJUST cu'n'ING HEIGHT
See "TO ADJUST CUI-rlNG HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your lawn mower, is
provided to minimize the possibility that
objects will be thrown out the rear of the
lawn mower into the operator's mowing
position.
If the rear deflector becomes damaged, it
should be replaced.
TO ADJUST HANDLE
The handle can be mounted in a high o
low position. The mounting holes in th_
bottom of lower handle are off center fo
raising or lowering the handle.
• Remove upper handle and all parts
attached to lower handle.
• Remove hairpin cotters from lower
handle bracket mounting pin.
• Squeeze lower handle in to remove it
from mounting pins.
• Turn lower handle over to raise or Io_
handle.
• Squeeze lower handle in and positior
holes onto mounting pins on handle
bracket.
• Reassemble upper handle and all pa
removed from lower handle.
Lower
,,-";__: handle
Rotate
12
Loading ...
Loading ...
Loading ...