Loading ...
Loading ...
Loading ...
10
WWW.VINOTEMP.COM
OPERATING YOUR FRIDGE
INSTALLING THE HANDLE
This fridge/cooler includes a handle that is not required to operate this unit. To install
the handle please follow the below instructions:
Locate the handle(1) over the pin(3) of the door and tighten the handle by screwing the Allen
key grub screws(2).
CAUTION:do not overtighten the screws.
INSTALLING THE CHARCOAL FILTER
To install the charcoal filter, please follow the below instructions:
•
Place the carbon filter on top the wooden shelf.
•
The back of the filter has a 3M glue tape which you can
affix to the shelf or the inside of the unit.
The fridge/cooler should be placed in a position where the ambient temperature is between 5-38°C/41-
100°F. Humidity level is between 45-90%. If the position is above or below this range,
the performance of the
unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior
temperature to fluctuate.
NOTE:
!
When you use the fridge/ cooler for the first time or restart the fridge/ cooler after having been
shut off for a long time, there could be a few degrees variance between the temperature you select and the
one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the
fridge/ cooler is running for a few hours everything will be back to normal.
!
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit.
If you attempt to restart before this time delay, the fridge will not start.
Loading ...
Loading ...
Loading ...