Loading ...
Loading ...
Loading ...
THE BRUSHES
When brushes are worn and bristles do
not touch the edge of a card held
across the nozzle, they should be re-
placed. Always replace both brushes
at the same time to maintain clean-
ing efficiency.
TO REPLACE THE BRUSHES
1. (Disconnect the Cleaner from
Electrical Outlet) before replacing
brushes.
2. To replace worn brushes, remove
bottom plate, belt and agitator, fol-
lowing directions given on Page 10.
Turn end plate of agitator in opposite
direction until one plate comes off.
3. Then pry out end section.
4. After end section is removed, tap
the shaft gently with a hammer.
5. Pull shaft from agitator.
6. Remove brushes by forcing out
with screwdriver. Replace with new
brushes. Slide them into the channel
and push in as far as possible.
7. Replace shaft, lining up the Iocator
on shaft with slot on the agitator.
Replace other end section and end
plate and tighten. Replace agitator in
cleaner. (See Page 11.)
12
Loading ...
Loading ...
Loading ...