Loading ...
Loading ...
Loading ...
11
CONNECTING AND REMOVING BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the power tool for the first time, place
the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the
instructions in the battery charger section.
To install the battery pack
To install the battery pack into the bottom of the handle, align the rails of the battery pack with the rails in
the handle and push the battery into the handle. To connect the battery, slide the battery pack fully
forward. Until the latch locks into place.
To remove the battery pack
Press the battery release button ,Slide the battery pack backward, and then pull or lift the battery out of
the tool .
WARNING:
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.
• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on
any part of the power tool.
• Read, understand, and follow the instructions.
OPERATING INSTRUCTION
Turbo button
A function of increase in airflow “turbo” , is used only on occasions when leaves and trash is stuck
or when the normal airflow is not sufficient . In most cases , normal airflow is sufficient. An increase
in airflow is used mainly for brief measures.
Switching On/Off
Hold the blower with one hand on the control
handle - wrap your thumb around the handle.
Pull the trigger with your index finger and hold it
there. The blower accelerates and air flows from
the nozzle.
To switch off, release the On/Off trigger switch.
No air flows from the nozzle.
Using the Blower
Holding and Controlling the Blower
Hold and control the blower with one hand on the control handle - wrap your thumb around the handle.
Point the nozzle at the ground, walk slowly and steadily forwards.
Turbo button
On/Off trigger switch
Fig.3
Loading ...
Loading ...
Loading ...