Loading ...
Loading ...
Page 3 of 7
ASSEMBLY INSTRUCTIONS (continued)
5. Install the bulb (not included).
See relamping label at socket
area or packaging for
maximum wattage allowed.
Turn on the power at fuse or circuit box
211201
4
AA
DD
CC
AA
Green Grounding Screw
3
3. Pull out the source wires
from the outlet box. Make
wire connections using wire
connectors (CC) as follows:
• Connect the hot wire
(usually black insulation)
from the fixture to the
black wire from the power
source.
• Connect the neutral wire (usually white insulation) from
the fixture to the white wire from the power source.
• Attach the fixture grounding wire (usually green
insulation or bare wire) to the mounting plate unit (AA)
with the green grounding screw. Then, depending on
local code, connect it to the house grounding wire with
the wire connector (CC).
Carefully put all of the wires back into the outlet box.
4. Attach the backplate to mounting
plate unit (AA) by aligning holes,
secure the set screws (DD) from
the side hole of the backplate.
Note: With silicone caulking
compound, caulk completely
around where the backplate
meets with the wall surface to
prevent water from seeping into the outlet box.
Max.60W Type A Bulb
(not included)
5
The Position of Control Panel
Step 1: Rotate the sensor lens from left side to right side
to show the adjustable knobs and slide switch.
(See Fig.1)
Step 2: Adjust time, low level brightness and sensitivity by
turning the knobs and choose the mode you want
by sliding the switch. (See Fig.2 and Fig A).
Step 3: Restore the sensor lens to original position by
rotating the lens from the right side to the left.
(See Fig.3)
Fig.A
“Time” Knob
“Sens” Knob
Slide Switch
“Low Level” Knob
Time Low Level
Sens
Auto
Test
3min
PC
3H
Custom
5s
Fig.1
Sensor
Lens
Fig.3
Sensor
Lens
View Fig.A
Fig.2
Loading ...
Loading ...
Loading ...