Loading ...
Loading ...
Loading ...
Setting Warmer Drawer Controls
Warmer Drawer Indicator Light
Removing & Replacing Warmer Drawer
Warmer (Warm & Ready TM) Drawer Indicator Light (some models)
The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays on
until the control is turned OFF. The warmer drawer is inoperable during the Self-Clean cycle. The indicator light will not
come on during the Self-Clean cycle.
To Remove and Replace Warmer (Warm & Ready TM) Drawer (some models)
Left Glide
Pull up with finger
Remove Warmer Drawer:To
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Fig.1 ).
4. Pull the drawer away from the range.
Right Glide
Push down with finger
Fig. 1
Glide ___
Fig. 2
To Replace Warmer (Warm & Ready TM) Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Fig. 2).
2. Align the glide on each side of the drawer with the glide slots on the range.
3. Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE; The Warmer Drawer w!!!NOT operate while inthe Self-C!ean and !iOven
Lockout" modes
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
28
Loading ...
Loading ...
Loading ...