Loading ...
Loading ...
Loading ...
TO REPLACE HEADUGHT BULB
• Raise hood.
° Pul! bulb holder out of the hole in the
backside of the gdll.
o Replace bulb inholder and push bulb
holder securely back into the hole in the
backside of the gdlL
o Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
• Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
formed by an authorized engine manufac-
turer's service outlet.
TO REMOVE HOOD AND GRILL
ASSEMBLY
• Raise hood.
° Unsnap headlight wire connector.
° Stand in front of tractor° Grasp hood at
sides, tilt toward engine and lift off of
tractor.
o To replace, reverse above procedure°
Hood
_\ Headlight
t Wire
Connector
ENGINE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
° With engine not running, move throttle
control lever to fast position.
Check that swivel is against side of
quarter circle. If it is not, loosen cable
clamp screw and pull cable back until
swivel is against quarter circle. Tighten
cable clamp screw securely.
Clamp Screw _
Quarter Circle \ \ \ /
Swivel
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
° With engine not running, move choke
control (located on dash panel) to fuU
choke position°
° Remove air cleaner cover, filter and car-
tridge plate to expose carburetor choke
(see "AIR FILTER" in the Customer
Responsibilities section of this manual).
° Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw se-
curely.
• Reassemble air cleaner_
Choke Closed ".
Casing Clamp /
Screw
Choke
Lever
TO ADJUST CARBURETOR
The carburetor has been preset at the fac-
tory and adjustment should not be neces-
sary. However, minor adjustment may be
required to compensate for differences in
fuel, temperature, altitude or load. If the
carburetor does need adjustment, proceed
as follows:
29
Loading ...
Loading ...
Loading ...