Loading ...
Loading ...
Loading ...
OCCURRENCE POSSIBLE CAUSE SOLUTION
WATER
Wash load too wet after Washer isoverloaded. Donotoverioadwasher.See Washing Procedures.
spin.
Load is out of balance. Rearrangeload to allow proper spinning.
Drain hose iskinked. Straighten drain hose.
Water does not enter Water supply is not adequate in area. Checkanotherfaucetinthehouse. Waituntiiwater
washer or it enters slowly, supply and pressureincrease.
Water supplyfaucets are not completely open. Fullyopen hot and cold faucets.
Water isbeing usedelsewhere in the house. Water pressure must be at least 30 psi (260 kPa).
Avoid running water elsewhere while washer is
filling.
Water inlet hosesare kinked. Straighten hoses.
Water level does not cover Improper water levelselection(for modelswith Select higher water level/load size.
load. water level/load sizecontrol).
Washer isoverloaded. Do not overload washer. When control is set at
highest fill level,dryload levelshould not behigher
than top row of circular holes in wash tub.
Warm or hot water is not Hot water heater issettoo low or isa distance Measure hot water temperature at nearby faucet
hot enough, from washer, with candy or meat thermometer. Water
temperature should beat least 130°F(70°C).Adjust
water heater as necessary.
Hotwaterisbeing usedelsewhereinthehouse. Avoid using hot water elsewhere before or during
washer use. There may not be enough hot water
available for proper cleaning. If problem persists,
your hot water system may be unable to support
more than 1 useat a time.
Water in washer does not Drain hose iskinked or clogged. Clean and straighten the drain hose.
drain or drains slowly.
Water leaks. Fillhose connection at faucet or washer. Checkand tighten hoseconnections. Installrubber
sealingwashers provided.
House drain pipesare clogged. Unclog drain pipes. Contact plumber if necessary.
Oversudsing. Use lessdetergent.
Incorrect wash and rinse Hot and cold water hoses are connected to Connect hot water hose to hot water faucet and
temperatures, wrong supply faucets, cold water hose to cold water faucet.
Water is entering washer Drain hosestandpipe isincorrect height.
but tub does not fill.
Standpipe must be a minimum of 33" (83.82 cm)
high to prevent siphoning. See INSTALLATION
INSTRUCTIONS.
11
Loading ...
Loading ...
Loading ...