Loading ...
Loading ...
Loading ...
ing cycles are Energy Saver cycles that help prevent over-dry-
ing.
When a wet load is put into the dryer it takes a certain amount
of time to reach the desired dryness level. The time will vary
with load size, type of fabric, amount of moisture in the load,
air flow and the laundry room environment. The estimated
time will be shown in the digital display.
NOTE: The time shown before starting the cycle is esti-
mated by averaging the last 5 cycles run on the selec-
ted cycle/dryness combination.
Cycle Use
Regular Use for sturdy items like play
or work clothes.
Perm Press Use for permanent press
items and synthetics.
Delicate Dry delicate items on this cy-
cle.
Manual
There are three manual cycles: Time Dry, Quick Dry and Fluff
Up. These cycles will run for the set number of minutes shown
on the digital display. The cycle time can be increased or de-
creased using the up and down arrow keypads. The time and
temperature selection may be adjusted manually at any time
before or during the cycle.
Selections
The following selections can be used to modify the currently
chosen cycle. The default selections will be lit after choosing a
cycle.
Temp
Press the Temp keypad to change a Manual cycle’s tempera-
ture.
Choose from No Heat, Low or High.
Dryness
Press the Dryness keypad to change the dryness level in an
Auto-Sensing cycle. Choose from Damp, Near Dry or Dry.
Damp Leaves load slightly damp for
easier ironing.
Near Dry Use for normal loads.
Dry Use for heavy items such as
blue jeans and blankets.
Over-drying can cause wrinkling, shrinking, excessive lint con-
ditions, and will use more energy than necessary. To increase
energy savings and to make sure loads are dried without over-
drying, set your Auto-Sensing loads on Near Dry. If items are
damp or over-dry at the end of a cycle, increase or decrease
the Dryness setting the next time these loads are dried. Re-
member the settings that work best to get ideal drying results.
Moisture Level
The Moisture Level status lights will be lit during an Auto-Sens-
ing cycle. The Sensing light will be lit at the beginning of the
cycle.
The Wet and Dry lights will be lit based on readings from the
moisture sensing system.
Options
The following options can be used to modify the currently
chosen cycle.
Signal
Pressing the Signal keypad will change the end of cycle signal
volume. There are four settings: Off, Low, Medium, High.
Status
The Status lights are lit during the cycle to show what part of
the cycle is running.
Door Open The Door Open status light is
lit any time that the dryer
door is open.
Heating The Heating status light is lit
to indicate that a heat por-
tion of the cycle is currently
operating.
Cooling The Cooling status light is lit
during the cool-down portion
of the cycle.
NOTE: The Heating or Cooling status light flashes (1
second on/1 second off) during the warm-up period.
The status light stays lit until the motor starts running.
To Dry Clothes
This appliance shall not be used to dry off solvents or dry
cleaning fluids. Fabric softeners, or similar products, should
be used as specified by the fabric softener instructions.
IMPORTANT: Refer to the INSTALLATION INSTRUC-
TIONS before using dryer.
IMPORTANT: Before using dryer for the first time, use
an all-purpose cleaner or a detergent and water solu-
tion and a damp cloth to remove shipping dust from in-
side of dryer drum.
1. Sort items into separate loads.
NOTE: Remove all objects from pockets such as
lighters and matches.
Operating Your Dryer
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
11 Part No. D516900EN
Loading ...
Loading ...
Loading ...