Loading ...
Loading ...
Loading ...
INSTALLSEAT
Adjustseatbefore tightening adjustment
knob.
1, Remove adjustment knob and flat
washer securing seat to cardboard
packing and set aside for assembly of
seat totractor.
2, Pivot seat upward and remove from
the cardboard packing. Remove the
cardboard packing and discard.
3. Place seat on seat pen so head of
shoulder bolt is positioned over large
slotted hole in pan,
4. Push down on seat to engage
shoulder bolt in slot and pull seat
towards rear oftractor.
5. Pivot seat and pan forward and
assemble adjustment knob and flat
washer loosely. Do not tighten.
6. Lower seat into operating position and
sit in seat.
7. Slide seat until a comfortable position
is reached which a_lowsyou to press
clutch/brake pedal all the way down.
8. Get off seat without moving its
adjusted position.
9. Raise seat and tighten adjustment
knob securely,
Seat
NOTE: You may now rollor drive your
tractor off the skid. Follow the appropriate
instructionbelow to remove the tractor
fromthe skid.
TO ROLLTRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plunger and raise
attachment liftlever to its highest
position.
2, Release parking brake by depressing
clutch/brake pedal.
3. Place freewheel control in freewheel-
ing position to disengage transmis-
sion (See "TO TRANSPORT" inthe
Operation section of this manual),
4. Roll tractor forward off skid.
5. Remove banding holding deflector
shield up against tractor.
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
•qLWARNING: Before starting, read,
understand and follow all instructionsin
the Operation section ofthis manual Be
sure tractor is in a well-ventilated area, Be
sure the area in front of tractor is clear of
other people and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fillfuel
tank with gasoline,
3. Place freewheel control in "transmis-
sion engaged" position,
4. Sit on seat in operating position,
depress clutch/brake pedal and set
the parking brake.
5. Place motion control lever in neutral
(N) position.
6. Press liftlever plunger and raise
attachment lift leverto its highest
position.
7. Start the engine. After engine has
started, move throttlecontrol to idle
position.
8. Release parking brake.
9. Slowly move the motion control lever
forward and slowlydrive tractor off
skid.
10.Apply brake to stop tractor, set parking
brake and place motion control lever
in neutral position.
11.Turn ignitionkey to"OFF" position.
Continue with the instructionsthat follow.
Loading ...
Loading ...
Loading ...