Loading ...
Loading ...
Loading ...
HEAT LIVE RELAX
INSTALLATION GUIDE
This heater can either be mounted to a wall or used with the supplied castors and wheels. Please note the
following safety warnings:
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use the control
panel or castor supports when moving the heater (when not wall mounted). Keep combustible materials such as
furniture, pillows, bedding, papers, clothes and curtains at least 1 meter from the front & top of the heater and
keep them at least 0.5 meters from the sides and rear. Do not cover.
The heater has hot parts inside. It must NOT be used in potentially dangerous locations such as flammable,
explosive, chemical-laden or wet atmospheres. This heater is intended for general indoor domestic use ONLY.
This heater is not intended for use in wet or damp locations, such as a bathroom or any area containing a bath,
shower, wash basin or close to water or damp items. Never locate a heater where it may fall into a bathtub or
other water container. It must be positioned or installed so that the controls cannot be touched by a person in a
bath or shower. Do not immerse the power cord in any liquid (including water).
Never install or use the heater directly below a wall socket.
When fixing on a wall, the heater must be level, securely fixed & at the correct height (check with local authorities
if unsure). There must be at least 150mm between it and any barrier/wall to the sides, bottom or top to prevent
overheating or damage.
FITTING CASTORS and WHEELS
Make sure the heater is unplugged from the mains power. Turn the heater
upside down & rest on a protective
surface. Place a castor bracket over the designated slots and slide into position. This will cause the screw hole to
align. Securely fix in place screw provided. (do not over-tighten). Push the castors and wheels into the slots. Turn the
heater right side up & it is ready to connect to mains power. Note: The heater gets hot when in use, so it is best not
to move when in use. If it must be moved, use the castor brackets or control panel as points of contact.
WA
LL MOUNTING
Do
not fit the castors to the base of the heater. Make
sure the heater is unplugged from the mains power and
the wall is suitable for mounting the panel heater and
there are the correct clearances. Make sure the panel
heater is within 1 metre of a power socket. Mount the
supplied wall mounting hooks using the mountings
supplied. Ensure the screws used are appropriate for
the screws used are appropriate for this application.
Ensure the mountings are 525mm apart and 465mm
above floor level.
Loading ...
Loading ...
Loading ...