Loading ...
Loading ...
Loading ...
.
Check electrode gap with wire feeler gauge and
reset spark plug gap to recommended gap if
necessary (see Specifications).
5. Install spark plug and tighten firmly.
NOTICE You can purchase a new spark plug by
calling 1-888-331-4569.
_nspect Muffler and Spark Attester
Inspect the muffler for cracks, corrosion, or other
damage. Remove the spark arrester, if equipped, and
inspect for damage or carbon blockage, tf replacement
parts are required, make sure to use only original
equipment replacement parts.
_, WARNmNG Exhaust heat/gases could ignite
combustibles, structures or damage
fuel tank causing a fire, resulting in
death or serious injury.
Contact with muffler area could
cause burns resulting in serious injury.
, DO NOT touch hot parts and AVOID hot exhaust gases.
, Allow equipment to cool before touching.
, Keep at least 5 feet (1.5 m) of clearance on all sides of
pressure washer including overhead.
It is a violation of California Public Resource Code,
Section 4442, to use or operate the engine on any forest-
covered, brush-covered,or grass-covered land unless
the exhaust system is equipped with a spark attester, as
defined in Section 4442, maintained in effective working
order. Other states or federal ]udsd!ctions may have
similar taws.
Contact the original equipment manufacturer,retailer, or
dealer to obtain a spark arresterdesigned for the exhaust
system installed on this engine.
, Replacement parts must bethe same and installed in the
same position as the original parts.
NOTICE You can purchase a spark arrester by calling
1-888-331 °4569°
Air Cooling System
Over time debris may accumulate in cylinder cooling
fins and cannot be observed without partial engine
disassembly. For this reason, we recommend you
have a qualified Sears service dealer clean the cooling
system per recommended intervals (see Maintenance
Schedule). Equally important is to keep top of engine
free from debris. See Clean Debris.
Carburetor Adjustment
The carburetor on this engine is low emission. It is
equipped with a non-adjustable idle mixture valve. Top
speed has been set at the factory. If adjustment is
required, see an authorized service dealer.
_, CAUTION Excessively high operating speeds
could result in minor injury.
Excessively low speeds impose a heavy load.
o DO NOT tamper with governor spring, links or other parts
to increase engine speed. Pressure washer supplies
correct rated pressure and flow when running at
governed speed.
DO NOT modify pressure washer in any way.
AFTER EACH USE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts
and "freeze" pump action. Follow these procedures
after every use:
1. Shut off engine, turn off water supply, point gun in a
safe direction, press red button and squeeze trigger
to relieve trapped pressure and let engine cool.
WARNmNG The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected, which
could result in serious injury.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.
.
.
.
5.
6.
Disconnect hose from spray gun and high pressure
outlet on pump. Drain water from hose, gun, and
nozzle extension. Use a rag to wipe off the hose.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most
liquid in pump.
Coil high pressure hose on hose wrap provided on
accessory tray.
Store unit in a clean, dry area.
If storing for more than 30 days see Long Term
Storac_ on next page.
_, WARNmNG Fuel and its vapors are extremely
_1 lammable and explosive which couJd
cause burns, fire or explosion
resulting in death or serious injury.
WHEN STORING FUEL OR EQUIPMENT WiTH FUEL iN
TANK
, Store away from furnaces, stoves, water heaters, clothes
dryers, or other appliances that have pilot light or other
ignition source becausethey could ignite fuel vapors.
21
Loading ...
Loading ...
Loading ...