Loading ...
Loading ...
Loading ...
8
1886
Assembling the Light
Fan style may vary.
Note:
Fan style may vary.
Note:
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light ControlGlass
ON
T
urn P
o
w
er
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Partially install two light kit screws,
found in the hardware bag, through
the gasket halfway into the motor
housing as shown. It does not matter
which two screw holes you choose.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
Align the keyhole slots in the top of the upper
switch housing with the partially installed light
kit screws. Wrap the keyhole slots around the
screws and twist counterclockwise
Install the third screw. Tighten all three
screws securely.
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
Installing the Bulbs and Glass
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
2 of 2
Short Light Kit
Screw
BAG
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the hardware bag.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
Loading ...
Loading ...
Loading ...