Loading ...
Loading ...
Loading ...
7
INSTALLATION
UNPACKING AND CLEANING
Remove all packaging and securing tapes from the appliance.
To avoid injury and causing damage to the appliance, be extremely
cautious when using sharp or pointed tools to complete this task.
Keep children away from the packaging material - DANGER OF SUF-
FOCATION! Wash the inside and outside of the appliance with luke
warm water and a mild soap or detergent. Abrasive or corrosive
cleaning agents, steel wool, scouring sponges, or chemical cleaning
agents should not be used under any circumstances. A sponge, soft
brush or towel is recommended. After cleaning, thoroughly rinse and
dry. You may want to leave the doors open allowing the compart-
ments to ventilate for 20-30 minutes to get rid of residual odors.
Check with your local Environmental Agency for recommendations
on recycling packaging materials in your area.
POSITIONING THE APPLIANCE
The area in which the fridge is to be installed must be relatively cool,
dry, and suitably ventilated. The area must be protected against any
inclement weather (rain, snow) and excessive surface dust. To ensure
proper function, the appliance must be placed horizontally on a at,
rm, and stable surface resting level on all four supports. The oor
must be strong enough to support a fully loaded cabinet. Use wood
or metal shims to level the fridge if necessary.
Do not place the fridge close to heat sources (heater, stove, boiler,
chimney, etc.), and avoid prolonged exposure to direct sunlight. This
appliance uses the exterior walls to transfer heat from the inside of
the cabinet. Ensure that there is adequate space between the fridge
and neighboring walls or large objects. A minimum spacing of 3
inches (7.5 cm) is highly recommended. This will provide sucient
airow around the appliance resulting in more ecient operation and
longer appliance lifetime. Always keep the air vent openings of the
compressor housing cover free from dust and obstructions.
DOOR REMOVAL AND REVERSAL INSTRUCTIONS
NOTE: The direction in which your refrigerator doors open (door
swing) can be reversed, from left to right or right to left, by moving
the door hinges from one side to the other. Reversing the door swing,
should be performed, by a qualified person.
1. Remove top hinge cover
2. Remove top hinge with Philips screwdriver and lift freezer door o
of center hinge and set door aside.
3. Unscrew center hinge with Phillips screwdriver
Loading ...
Loading ...
Loading ...