Loading ...
Loading ...
Loading ...
EN
EXTERIOR SURFACES
Clean the surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove any
deposits or stains caused by food residues. To dry any
condensation that has formed as a result of cooking
foods with a high water content, leave the oven to cool
completely and then wipe it with a cloth or sponge.
Activate the “Hydrocleaning” function for optimum
cleaning of internal surfaces.
• The door can be easily removed and refitted to
facilitate cleaning of the glass .
• Clean the glass in the door with a suitable liquid
detergent.
• To remove the remaining lime-scale from the
bottom of the cavity after the Steam cooking, just
pour 250 ml of white vinegar onto the embossing
of the cavity (alternatively, use a specific descaling
product. For availability please contact the After Sales
Service). Leave it to work at room temperature for 30
minutes, then clean the cavity with warm drinking
water and a soft cloth. Cleaning is recommended at
least for every 5 to 10 Steam cooking cycles.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
Do not use steam cleaning
equipment.
Use protective gloves during all
operations.
Do not cover the inside of the
oven with aluminum foil.
Carry out the required
operations with the oven cold.
Disconnect the appliance from
the power supply.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
MAINTENANCE
AND CLEANING
Download the Use and Care Guide from
docs . indesit . eu for more information
WWW
REMOVING AND REFITTING THE DOOR
1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
2. Close the door as much as you can.
Take a firm hold of the door with both hands – do
not hold it by the handle. Simply remove the door by
continuing to close it while pulling it upwards (a) at
the same time until it is released from its seating (b).
~60°
a
b
~15°
Put the door to one side, resting it on a soft surface.
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4. Lower the door and then open it fully.
Lower the catches into their original position: make
sure that you lower them down completely.
5. Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above.
CLICK TO CLEAN CLEANING THE GLASS
1.After removing the door and resting it on a soft
surface with the handle downwards, simultaneously
press the two retaining clips (1) and remove the upper
edge of the door by pulling it towards you (2).
1
2
2.Lift and firmly hold the inner glass with both
hands, remove it and place it on a soft surface before
cleaning it (3).
3
3.To correctly reposition the inner glass, make sure
that the “R” is visible in the left-hand corner and the
clear surface (not printed) is facing up. First insert the
long side of the glass indicated by “R” into the
support seats, then lower it into position (4). Refit the
upper edge (5): a click will indicate correct
positioning. Make sure the seal is secure before
refitting the door.
Loading ...