Loading ...
Loading ...
Loading ...
FPI FireGenie
TM
Remote Control Manual16
5) Secure Heat Shield onto Receiver with 2 x #10 x
1/2” screws. Ensure the bottom of the Heat Shield
is fl ush with the Receiver as shown in the diagram
below.
6) Re-install Battery Pack and Control Switch by
reversing steps 2 and 1 only.
3) Remove Receiver from Bracket and discard
bracket. (This Bracket is no longer required after
this step.)
Bracket Receiver
4) Place Heat Shield over Receiver. Be careful not
to crimp wires under edge of Shield.
Heat
Shield
Receiver
NOTE: After this step, installation of the E21 differs
from the rest of the units. Please follow steps specifi ed
for the E21.
Installing the Receiver to a Fireplace
1) Remove Control Switch from Remote Receiver
by pulling out gently.
Control
Switch
Remote
Receiver
2) Remove spring loaded Battery Pack by pushing
in and then pulling out.
Battery
Pack
Loading ...
Loading ...
Loading ...