Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
REQUIREMENTS
Tools and Parts
Gather required tools and parts before starting installation.
Tools Needed:
Adjustable or open end
wrench 9/16" (14 mm)
Level
Wood block Ruler or measuring tape
Adjustable pliers that
open to 1¾" (45 mm)
Flashlight
Bucket
Parts Supplied:
NOTE: All parts supplied for installations are in the washer.
Drain hose with clamp, U-form,
and cable tie
Parts Needed: (if not supplied with washer)
Inlet hoses with flat washers
NOTE: Various inlet hose
options are available; check
your Quick Start Guide for
ordering information.
Alternate Parts: (not supplied with washer)
Your installation may require additional parts. To order, please
refer to the contact information referenced in your Quick Start
Guide.
If you have:
You will need:
Overhead sewer Standard 20 gallon (76 L) 39" (990 mm)
tall drain tub or utility sink, sump pump,
and connectors (available from local
plumbing suppliers)
1" (25 mm) standpipe 2" (51 mm) diameter to 1" (25mm)
diameter standpipe adapter and
connector kit
Drain hose too short Extension drain hose and connector kit
Lint-clogged drain Drain protector and connector kit
Location Requirements
Select proper location for your washer to improve performance
and minimize noise and possible “washer walk.” Install your
washer in a basement, laundry room, closet, or recessed area.
IMPORTANT: Do not install, store, or operate washer where it will
be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in washer after use may cause damage in low
temperatures. See “Washer Maintenance and Care” for
winterizing information.
Proper installation is your responsibility.
You will need:
n A water heater set to 120°F (49°C).
n A grounded electrical outlet located within 4 feet (1.2 m) of
power cord on back of washer.
n Hot and cold water faucets located within 3 feet (0.9 m) of hot
and cold water fill valves on washer, and water pressure of 20–
100 psi (138–690 kPa).
n A level floor with maximum slope of 1" (25 mm) under entire
washer. Installing on carpet or surfaces with foam backing is
not recommended.
n Floor must support washer’s total weight (with water and load)
of 315 lbs. (143 kgs).
Recessed area or closet installation
NOTE: All 27" wide washers should have 19" clearance, while all
29" wide washers should have 22" clearance.
Loading ...
Loading ...
Loading ...