Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
⚫ Remove the exterior and interior packing.
⚫ Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
⚫ Clean the interior surface with lukewarm water using a soft cloth.
⚫ Install the handle, stored inside the unit. Install using the supplied screws.
Installation of Your Appliance
⚫ This appliance is designed for freestanding or built-in (fully recessed) installation. If freestanding,
the unit should have at least 4in of clearance at both sides, at the top, and at the back to allow for
adequate ventilation. If it is built-in, leave 3/16
inches at both sides, 1/16
inches at the top, and 2
inches at the rear. Be sure that airflow under the appliance is not blocked.
⚫ Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level
your appliance, adjust the front leveling legs at the bottom.
⚫ Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and the heat may increase electrical consumption.
Extremely cold ambient temperatures may also cause the unit not to perform properly.
⚫ Avoid locating the unit in moist areas.
⚫ Plug the appliance into an exclusive, properly installed, and grounded wall outlet. Do not under
any circumstances cut or remove the third (grounding) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified and authorized products
service center.
Loading ...
Loading ...
Loading ...