Loading ...
Loading ...
Loading ...
10
Operation and Controls
It is recommended you install the appliance in a place where the ambient temperature is between 72º- 78ºF /
23º-26ºC. If the ambient temperature is above or below recommended temperatures, the performance of the
beverage refrigerator may be affected. For example, placing your appliance in extreme cold or hot conditions
may cause interior temperatures to fluctuate.
NOTE:
When using the beverage refrigerator for the first time or restarting after being shut off for a long period of
time, there may be a few degree variance between the set temperature and the LED readout. This is nor-
mal due the length of activation time. The unit should return to normal after running for a few hours. This
unit will not raise its internal temperature if the ambient temperature where the unit is located is lower than
the set temperature.
CONTROL PANEL GUIDE
POWER
To turn the appliance on/off, press and hold the power key for 5 seconds.
UP
To increase (warm) the set temperature by 1°C or 1ºF.
DOWN
To decrease (cool) the set temperature by 1°C or 1ºF.
LIGHT
Used to turn the internal light on/off.
ºF/ºC SELECTOR
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5 seconds.
NOTE: If the appliance is unplugged, encounter power interruption, or turned off, you must wait 3 -5
minutes before restarting the appliance. If attempted to restart before this time delay, the appliance may not
start.
SETTING THE TEMPERATURE CONTROL
During normal operation, the temperature display on the control panel shows the temperature inside the
appliance.
When the unit is plugged in for the first time, the unit will power up automatically to the preset defaults.
The preset temperature is 54ºF (12ºC).
You can press the UP and DOWN keys to control the internal temperature of the appliance.
The temperature that you desire to set will increase 1ºC or 1ºF if you press the UP key once and will de-
crease 1ºC or 1ºF if you press the DOWN key once. The display flashes while you make the setting.
After the temperature has been set, the display will flash four times before it shows the current internal
temperature of the particular temperature zone.
To view the set temperature at any time, press the UP or DOWN key, the set temperature will temporarily
flash in the display for 5 seconds. Then the display shows the current internal temperature again.
Loading ...
Loading ...
Loading ...