Loading ...
Loading ...
Loading ...
I Installation Instructions I Range
I ffyou have questions, call 1.800.GE.CARESor ,isit our _:ebsite at: ge.com
I
I
In the Commonwealth of Massachusetts:
• This product Inust be installed bv a licensed phunber
or gas fitter.
* When using ball-tyI)e gas shut-offvalves, they shall be
the T-handle type.
" A flexible gas connect(n; when used, must not exceed
3 tibet.
BEFORE YOU BEGIN
Read these h_slructions completely and cm'efully.
Installation of this rmlge must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Cmlada, installation must conform
with the current Natural Gas Installation Code,
CAN/CGA-B149.1 or the current Propmle Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest
edition and Canadiml Gas Association according to
CAN/CGA-I.1 latest edition.
As with any appliance using gas and generating heat,
there are certain safety precautions you should tollow.
You will find these i)recautions in the Important SafoW
Information section in the front of this manual. ]lead
them careflfllv.
•IMPORTANT - S ,,ethe ein t ,,cti,m
tot local electrical inspector's use.
•IMPORTANT - O,...e ,ll>,.nin
codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consume_:
• Note to Consumer - Keep these instructions tor
tim]re reference.
• Note - This appliance must be propedy grounded.
• Servicer - The electrical diagram is in an envelope
attached to the back of the range.
• Skill level - Installation of this appliance requires basic
mechanical skills.
• Proper installation is the responsibility of the installe_:
• Product tifilure due to improper installation is not
covered under the _'arranw.
PART INCLUDED
Anti-Tipbracketkit
32
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flmmnable vapors mid liquids in the vichfity of this
or m_y other appfimace.
If you smell gas:
Open windo_vs.
_ Don't touch electrical switches.
Extinguish any open flame.
hnmediately call your gas suI_plie_:
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-bladescrewdriver Open-endor
adjustablewrench
Pencilandruler __
Level
Pipewrenches(2) _:::_:::=:::=:::_"
(one for backup) Drill, awl or nail
MATERIALS YOU MAY NEED
• Gas line shut-otfvalve.
• Pipe joint sealant or Ui,-ai)proved pipe thread tape
with Teflon':: that resists action of natural and I,P gases.
• Flexible metal appliance connector (l/2" I.D.)
A 5-toot length is recommended tot ease ot installation
but other lengths are acceptable. Never rise an old
connector when installing a new range,
• Flare union adapter tot connection to gas suI)ply line
(3/4" or 1/2" NPT x 1/9" I.D.)
• Flare union adapter for connection to pressure
regulator on range (1/2" NPT x 1/2" I.D.)
• I,iquid leak detector or soapy water;
• I,ag bolt or l/2" O.D. sleeve anchor (fi)r concrete
floo_ only).
*'Ibflon: Registered t_-ademarkof DuPont
Loading ...
Loading ...
Loading ...