Loading ...
Loading ...
Loading ...
9
for 2 seconds. When Leds light on, press buttons:
(within 5 seconds). Leds ashing 6 times indicate
the procedure is completed.
WARNING! This operation deletes permanen-
tly the preset codes.
Emergency button:
In the event that the radio control does not work,
use the emergency button to switch the appliance
off. After any necessary repairs have been perfor-
med, reset the emergency button.
WARNING
The battery should be replaced every year to
guarantee the optimal range of the transmitter.
To replace the exhausted battery, take the pla-
stic lid off, remove the battery and replace it
with a new one, observing the correct battery
polarities.
Used batteries should be discarded in special
collection bins.
The below product:
RC001 Radiio Controll
complies with the specications set out in the
R&TTE Directive 99/5/EC.
WARNING
Any adjustments or modications which have
not been expressly approved by the holder of
the legal conformity certicate may invalidate
the user’s rights relating to the operation of
the device.
The products are endowed with an electronic de-
vice which allows the automatic switching off after
4 hours working from the last operation.
- An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
- Particular care is due to the grease lter. It can
be removed by pushing its special handle toward
the back-side of the cooker hood and turning the
lter downwards so to unfasten it from its slot
(Pic. 3).
To insert the lter just perform the opposite ope-
ration.
After 30 hours working, the push button control
panel will signal the saturation of the grease lter
by lighting all the buttons. Press the timer button
to reset .
The grease lter needs cleaning by regular hand-
washing or in dishwashers every two months at
least or depending on its use.
- How to remove the oil tank.
First, remove the grease lter, Than place your
hand under the oil tank and unfasten the handles
(Pic. 9) Eventually remove the oil tank, paying at-
tention to the leaking oil.
- To clean the appliance itself tepid water and
neutral detergent are recommended, while abra-
sive products should be avoided. For steel ap-
pliances specialized detergents are recommen-
ded (please follow the instructions indicated on
the product itself to obtain the desired results).
* If the supply cord is damaged, it must be re-
placed by the manufacturer or its sevice agent
or a similarly qualied person in order to avoid
a hazard.
Replacing the lamps
Before replacing the lamp switch off the applian-
ce then by using appropriate tools remove the
lamp from its slot (Pic. 10).
Take out the led bar from its connector and repla-
ce with one having similar characteristics.
To nd the correct led bar please check on the
replacement part list.
To remove the appliance from the cabinet is ne-
cessary to remove the installation bracket by the
eight nuts, as shown in the picture 11.
MAINTENANCE
Loading ...
Loading ...
Loading ...