Loading ...
Loading ...
Loading ...
WATER FILTER
It is recommended that you replace the water filter:
• Approximately every 6 months.
• When the water filter indicator turns on.
• When the water dispenser output decreases.
• When the ice cubes are smaller than normal
1. Remove the old water filter.
Press the push button to open the
water filter cover.
NOTE: Replacing the water filter
causes a small amount of water
(around 1 oz. or 25 cc) to drain. Place
a cup under the front end of the water filter cover to
collect any leaking water. Hold the water filter upright,
once it is removed, to prevent any remaining water from
spilling out of the water filter.
Pull the water
filter downward
and pull out.
Make sure to
rotate the filter
down completely
before pulling
it out of the
manifold hole.
2. Replace with a new water Niter.
Take the new water filter out of its packing and remove
the protective
cover from the
o-rings. With the
water filter tabs
in the horizontal
position, push the
new water filter
into the manifold
hole until it stops.
Rotate the water
filter up into
position and
close the cover.
The cover will
click when closed
correctly.
3. After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5 minutes)
to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
NOTE: To purchase a replacement water filter, visit a
Sears store or call 1-800-4-MY-HOME ®. You may also
order on-line at www.sears.com/partsdirect
25
Loading ...
Loading ...
Loading ...