Loading ...
Loading ...
Loading ...
If the oven is heavily soiled, excessive flareups may result in
a fault code during cleaning. Press the CANCEL pad and
allow the oven to cool completely, wipe out excess soil, then
reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
Noises may be heard.
The oven makes several low level noises. You may hear the
oven relays as they go on and off. This is normal.
As the oven heats and cools, you may hear sounds of metal
parts expanding and contracting. This is normal and will not
damage your appliance.
9
There are no beeps and no display.
, Oven may be in Sabbath Mode. See page 16.
SAb flashing and then displayed continuously.
Oven is in Sabbath Mode. To cancel, press and hold the
Clock pad for five seconds.
SurfeceCookin9
Surface Controls
Use to turn on the surface elements. An infinite choice of
heat settings is available from Low to High. The knobs can
be set on or between any of the settings.
4.
When a control is turned on, a glow can be seen through
the smoothtop surface. The element will cycle on and off
to maintain the preset heat setting, even on High.
After cooking, turn knob to OFF. Remove pan.
Setting the Controls
1. Place pan on surface element.
2. Push in and turn the knob in either direction to the desired
heat setting.
, The control panel is marked to identify which
element the knob controls. For example, the
graphic at right indicates left front element.
OO
OO
3. There is an element indicatorlight on the control panel.
When any surface control knob isturned on, the light will
turn on. The light will turn off when all the surface
elements are turned off.
Dual Elements
The cooking surface has two dual elements
located in the right front and left front of
the smoothtop. This allows you to change
the size of these elements.
Press the switch to the left to use the
large element or to the right to use the
small element. The selection should be
made before turning on the element.
OFF
©
Loading ...
Loading ...
Loading ...