Craftsman 917378891 lawn mower

User Manual - Page 6

For 917378891.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
TO REMOVE LAWN MOWER FROM
CARTON
1. Removeloose parts includedwith
mower.
2. Cut down two end cornersof carton
and lay end paneldown flat.
3. Removeall packingmaterialsexcept
paddingbetweenupperand lower
handleand paddingholdingoperator
presencecontrolbar to upperhandle.
4. Roll lawn mowerout of carton and
checkcarton thoroughlyfor additional
looseparts.
HOWTO SET UPYOUR LAWN
MOWER
TO UNFOLDHANDLE
iMPORTANT: Unfold handle carefully so
as not to pinch or damage control cables.
1. Raise handles until lower handle sec=
tion locks into place in mowing position.
2. Remove protective padding, raise up=
per handle section into place on lower
handle and tighten both handle knobs.
3. Remove handle padding holding
operator presence control bar to upper
handle.
Your lawn mower handle can be adjusted
for your mowing comfort. Refer to "AD-
JUST HANDLE" in the Service and Adjust-
ments section of this manual.
Operator presence
control bar
LiFT
Mowing
position
Lower handle
TO ASSEMBLE GRASS CATCHER
1. Putgrasscatcherframeintograssbagwith
rigid part of bag on the bottom. Make sure
the frame handle is outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Catcher
frame
handle
Frame
opening
TO iNSTALL ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mutcher. To convert mower to
bagging, see "TO CONVERT MOWER" in
the Operation section of this manual.
TO PREPARE BATTERY
NOTE: Your battery must be charged
before you can start your lawn mower.
1, Connect battery charger connector
(male) to harness connector (female).
2, Plug battery charger into 110 volt A,C,
outlet.
3, Leave battery charger connected for
24 hours before starting your engine
for the first time,
4, After charging, disconnect harness
connector (female) from battery char-
ger connector (male),
Connect your battery charger to charge
battery after each use.
iMPORTANT: The engine will not re=
charge your battery,
At the end of the mowing season the
battery should be charged for 48 hours to
,_otect the battery during winter storage,
CAUTION: Always disconnect the
engine connector (male) from the battery
connector (female) to prevent accidental
starting when transporting or storing your
lawn mower after the season,
Engine \ Harness
connector connector
(male) ale)
Charger
connector (male)
Loading ...
Loading ...
Loading ...