Fisher & Paykel DE60F60NW1 6kg Condenser Dryer

Installation instructions and User guide - Page 7

For DE60F60NW1.

PDF File Manual, 20 pages, Read Online | Download pdf file

DE60F60NW1 photo
Loading ...
Loading ...
Loading ...
5
Electrical connection
Connect the machine to an earthed outlet protected by a fuse of suitable capacity.
Important!
ß
Connection should comply with national regulations.
ß
Power cord plug must be within easy reach after installation.
ß
The voltage and the allowed fuse protection are specified in the section ‘Technical specifications
(page 4).
ß
The stated voltage must match with your mains voltage.
ß
Connection via extension cords or multi-plugs should not be made.
ß
The main fuse and switches must have a contact distance of minimum 3 mm.
ß
A damaged power cable must be replaced by a qualified electrician.
ß
The appliance must not be operated unless it is repaired! There is the risk of electric shock!
Products equipped with a condenser unit accumulate water during the drying cycle, which is
collected in the water tank. The accumulated water should be drained after each drying cycle.
Connection to a water drain
The TANK FULL warning LED will light up at the end of
each programme.
You can directly send the accumulated water out
through the water drain hose supplied with the machine
instead of periodically draining the water collected in
the water tank.
Connecting the water drain hose:
1
Remove the hose on the machine by pulling it out from
its end. Do not use any tools to take out the hose.
Attach the drain hose adaptor to the end of this hose.
2
Connect the special drain hose supplied with the
machine to the hose adaptor fitting.
3
The other end of the drain hose can be directly
connected to the wastewater drain or to the washbasin.
The fitting must always be secured in all types of
connections. Your house may be flooded if the hose gets
out of its housing during water discharge.
Important!
ß
The hose should be attached to a maximum height of 80 cm.
ß
You must be careful not the pinch or bend the hose.
ß
The end of the hose should not be bent, it should not be stepped on and it must not be folded
between the drain and the machine.
Installation options
Fig.2 Connecting to a water drain
Loading ...
Loading ...
Loading ...